90 CBLé System Guidebook
Glossary
Filter
A parameter in the Sample and Trigger Setup command that defines the
kind of noise filtering to perform during data collection.
Mode
One of three operating modes of the CBL
communications, multimeter, or
internal.
Operation
A parameter in the Channel Setup command that defines what the
channel is to measure, e.g., voltage, resistance, frequency, etc.
Post-Processing
A parameter in the Channel Setup command that defines the type of
processing to perform on the data after it is collected.
Prestore Sample
A parameter in the Sample and Trigger Setup command that specifies the
percentage of data samples to collect before the trigger event occurs.
Ready
The state of the CBL immediately after a Sample and Trigger Setup
command is sent from the calculator. The CBL is ready to collect data.
Record Time
A parameter in the Sample and Trigger Setup command that specifies
whether CBL records absolute or relative time during data collection.
Statistic Samples
A parameter in the Channel Setup command that defines the number of
samples to collect per computed Statistic point when Statistics Post-
Processing is selected.
Trigger Channel
The channel that is initialized to sense the trigger event or condition.
Trigger Threshold
A parameter in the Sample and Trigger Setup command that defines the
required input level where triggering begins.
Trigger Type
A parameter in the Sample and Trigger Setup command that defines the
event or condition that causes data collection to begin.
To Next Page
Loading...
Need help?
General
