Connecting to the Advanced Remote Control
www.ti.com
NOTE: This action causes the HID dongle to scan for an ARC for 5 seconds. While scanning, the
red LED will blink once a second.
2. Press any key on the ARC to start advertising.
NOTE: When a suitable advertisement is found, the CC2540 USB dongle connects, pairs, and
exchanges long-term bonding information with the remote, performs discovery of the
services and characteristics used by the HID over GATT profile, and enables GATT
notifications to be sent for button presses and mouse movements from the advanced remote.
The green LED lights up when the connection is alive, and the red LED blinks when data is
received. The connection is terminated to save power after the advanced remote has been
idle for 60 s.
Figure 3-2. SW1 - Clear Bonding Information
SW2 - Scan and Pair With Advanced Remote Control
Sequence:
10
Using the CC2540 USB Dongle SWRU343A–April 2013–Revised June 2015
Submit Documentation Feedback
Copyright © 2013–2015, Texas Instruments Incorporated
To Next Page
Loading...
