Using the Mouse
www.ti.com
5.4 Using the Mouse
Holding down the middle mouse button prompts the advanced remote to interpret the movement of the
remote as mouse input, and send this input to the computer.
Double-clicking the middle button locks the mouse function. The left and right buttons act as left and right
mouse buttons.
Pressing AV and –/– decreases and increases mouse speed.
5.5 Removing Bond Information
Pressing the Red action key removes the bonding information stored on the advanced remote. Pairing can
be redone using a passkey entry if applicable. If the remote is in a connection, the connection is dropped,
and the bonding information is erased.
5.6 Calibrating
1. Ensure the mouse function is off and the device is laying on a flat surface.
2. Press the Blue action key to recalibrate the onboard motion sensors.
NOTE: If the advanced remote is not ready for calibration, a high-pitched note sounds.
3. Press the blue key again
NOTE: During calibration, a low-pitched tick sounds for 12 seconds. A high-pitched note indicates
success.
18
Using the Advanced Remote Control SWRU343A–April 2013–Revised June 2015
Submit Documentation Feedback
Copyright © 2013–2015, Texas Instruments Incorporated
To Next Page
Loading...
