www.ti.com
System Requirements
Figure 2-1. Hardware Included with the CC2541ARC
The RF boards in this kit are FCC- and IC-certified, and tested to comply with ETSI/R&TTE over
temperature from 0 to 35°C.
CAUTION
The kits include a non-rechargeable lithium battery. Always make sure the
battery is removed from the CC2540/41 keyfob when it is connected to an
external power source. Do not apply voltage less than 3.6 V. Dispose of the
battery properly, and keep out of the reach of children. If swallowed, contact a
physician immediately.
CAUTION
The kits contain ESD sensitive components. Handle with care to prevent
permanent damage.
2.2 System Requirements
2.2.1 Dongle
To use the CC2540 USB dongle as a bridge between the advanced remote control and a host computer,
you only need USB HID support in the operating system.
For computers without Bluetooth low energy-capable hardware and native support for the HID over GATT
profile in the operating system, use the dongle because it hides the wireless aspect from the operating
system.
Ensure the PC has a free USB port. An additional free USB port is required to use the CC debugger and
the USB dongle simultaneously.
7
SWRU343A–April 2013–Revised June 2015 Introduction
Submit Documentation Feedback
Copyright © 2013–2015, Texas Instruments Incorporated
To Next Page
Loading...
