Using SmartRF Flash Programmer Software
www.ti.com
NOTE: If reading from the CC2540/41, under Flash image enter the path and filename for the hex
file.
3. To write to the CC2540/41 under Actions, select Erase, program and verify.
4. To read from the CC2540/41 under Actions, select Read flash into hex-file.
5. To begin the read or write, click Perform actions.
NOTE: If the action completes successfully, the progress bar at the bottom of the window should fill
up and you will see either one of the following two messages: CC254X - IDXXXX: Erase,
program and verify OK or CC254X - IDXXXX: Flash read OK.
There are two pre-built hex image files for the advanced remote kit in the Accessories folder of the BLE-
Stack installation path.
Table 6-1. Hex Image Files
Project Directory
HIDAdvRemote \Accessories\HexFiles\CC2541_ARC_HIDAdvRemote.hex
HIDAdvRemoteDongle \Accessories\HexFiles\CC2540_USBdongle_HIDAdvRemoteDongle.hex
6.3.2 Reading or Writing the CC2540/41 Device Address
Every CC2540/41 device comes pre-programmed with a unique 48-bit IEEE address. This address is the
primary address of the device and is unable be changed. You can set a secondary address on a device to
override the primary address upon powerup. You can use flash programmer to read the primary address
and read or write the secondary address. See the TI Bluetooth low energy Software Developer’s Guide
(SWRU271) for more information.
6.4 Using IAR for Debugging and Programming
IAR is the compiler and IDE to develop the advanced remote and HID dongle. See the TI Bluetooth Low
Energy Software Developer’s Guide (SWRU271) for more information on using IAR,. This section provides
a high-level overview of advanced remote kit software projects. There are two projects for the advanced
remote kit.
Table 6-2. Advanced Remote Kit Software Projects
Project Directory
HIDAdvRemote \Projects\ble\HIDAdvRemote
HIDAdvRemoteDongle \Projects\ble\HIDAdvRemoteDongle
24
Programming and Debugging the CC2541 Advanced Remote SWRU343A–April 2013–Revised June 2015
Submit Documentation Feedback
Copyright © 2013–2015, Texas Instruments Incorporated
To Next Page
Loading...
