Texas Instruments CC2541 - 6 Programming and Debugging the CC2541 Advanced Remote; Hardware Setup for Advanced Remote; Advanced Remote Programming Setup

Chapter 6
SWRU343A–April 2013–Revised June 2015
Programming and Debugging the CC2541 Advanced
Remote
The CC debugger lets you debug using the IAR Embedded Workbench for 8051. The debugger also lets
you read and write hex files to the CC2540/41 flash memory using the SmartRF™ Flash Programmer
software. The hex files are included with the installer. SmartRF Flash Programmer can also change the
IEEE address of the CC2540/41 device. This section details the hardware setup using the CC debugger
and includes information on using SmartRF Flash Programmer. You can find information on using IAR
Embedded Workbench for debugging in the TI Bluetooth low energy Software Developer’s Guide
(SWRU271).
6.1 Hardware Setup for Advanced Remote
The debug port is on the back of the remote.
• Connect the debugger as shown in Figure 6-1.
Figure 6-1. Advanced Remote Programming Setup
19
SWRU343A–April 2013–Revised June 2015 Programming and Debugging the CC2541 Advanced Remote
Submit Documentation Feedback
Copyright © 2013–2015, Texas Instruments Incorporated