www.ti.com
Using SmartRF Flash Programmer Software
Figure 6-3. Flash Programmer
NOTE: If you are prompted to update the EB firmware (CC debugger), follow the instructions to
update the program.
6.3.1 Reading or Writing a Hex File to the CC2540/41
To read or write a hex file to the CC2540/41, do the following:
1. Select the System-on-Chip tab (default).
NOTE: The connected CC2540/41 should be detected and show up in the list of devices.
2. Under Flash image, select a hex file to write to the device.
23
SWRU343A–April 2013–Revised June 2015 Programming and Debugging the CC2541 Advanced Remote
Submit Documentation Feedback
Copyright © 2013–2015, Texas Instruments Incorporated
To Next Page
Loading...
