Texas Instruments DLP LightCrafter 4500

www.ti.com Revision History
19
DLPU017B–March 2014–Revised February 2018
Submit Documentation Feedback
Copyright © 2014–2018, Texas Instruments Incorporated
Revision History
Revision History
Changes from A Revision (September 2014) to B Revision .......................................................................................... Page
• Added information about what to do if the device does not connect to the GUI ................................................ 16
• Updated GUI screenshot of the firmware upload window .......................................................................... 16
• Updated GUI screenshot of the firmware upload process.......................................................................... 17
• Added missing link to the Flash Programming Procedure ......................................................................... 17
• Added missing link to the Flash Programming Procedure ......................................................................... 18
Changes from Original (March 2014) to A Revision ....................................................................................................... Page
• Included installation of LightCrafter 4500 GUI to procedure......................................................................... 2
• Added steps regarding flash programming procedure ............................................................................... 4
• Changed procedure to flash only first 128 kB of firmware through JTAG ......................................................... 9
• Added step to connect LightCrafter 4500 to PC..................................................................................... 15
• Added step to upload entire DLPR350 PROM through LightCrafter 4500 GUI ................................................. 16