EasyManua.ls Logo

Texas Instruments Metawatch MSP-WDS Series - MSP Debug Probe Overview

Texas Instruments Metawatch MSP-WDS Series
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MSP Debug Probe Overview
www.ti.com
4
SLAU647FJuly 2015Revised December 2016
Submit Documentation Feedback
Copyright © 2015–2016, Texas Instruments Incorporated
MSP Debuggers
2 MSP Debug Probe Overview
Table 1 is an overview of the capabilities and features for the available MSP debug probes.
CAUTION
Never disconnect the JTAG or emulator USB cable during an active debug
session. Always terminate a running debug session properly, by clicking on the
"Terminate" icon, before disconnecting the target device.
(1)
The MSP-FET430PIF is for legacy device support only. This emulation tool does not support any devices released after 2011.
(2)
See Section 3.1 to identify the hardware.
(3)
The eZ-FET Emulation IP and eZ-FET Lite Emulation IP are used as the onboard emulation for the MSP LaunchPad tools.
(4)
See Section 5.5 for more information.
(5)
The 2-wire JTAG debug interface is also referred to as Spy-Bi-Wire (SBW) interface.
Table 1. Debug Probes Features and Device Compatibility
(1)(2)(3)
Feature and MSP430 Device Support
eZ430-F2013
eZ430-RF2500
eZ430-RF2480
eZ430-RF2560
MSP-WDSxx Metawatch
eZ430-Chronos
LaunchPad (MSP-EXP430G2)
MSP-EXP430FR5739
MSP-EXP430F5529
MSP-FET430PIF
MSP-FET430UIF
MSP-FET
eZ-FET Emulation IP
eZ-FET Lite Emulation IP
Supports all programmable MSP430 and
CC430 devices
Supports only F20xx, G2x01, G2x11,
G2x21, G2x31
Supports F20xx, F21x2, F22xx, G2x01,
G2x11, G2x21, G2x31, G2x53
Supports F20xx, F21x2, F22xx, G2x01,
G2x11, G2x21, G2x31
Supports F5438, F5438A
Supports BT5190, F5438A
Supports only F552x
Supports FR57xx, F5638, F6638
Supports only CC430F613x
Supports MSP432Pxx
Allows JTAG access protection
(Fuse Blow)
(4)
Adjustable target supply voltage
Fixed 2.8-V target supply voltage
Fixed 3.3-V target supply voltage
Fixed 3.6-V target supply voltage
4-wire JTAG
2-wire JTAG
(5)
BSL tool or mode
Backchannel UART
Supported by CCS for Windows
Supported by CCS for Linux
Supported by CCS for OS X

Related product manuals