www.ti.com
Revision History
47
SPRZ412K–December 2013–Revised February 2020
Submit Documentation Feedback
Copyright © 2013–2020, Texas Instruments Incorporated
Revision History
Revision History
Changes from November 16, 2018 to February 13, 2020 (from J Revision (November 2018) to K Revision) ........... Page
• Section 4.1 (Usage Notes): Added SYS/BIOS: Version Implemented in Device ROM is not Maintained usage note....... 3
• Section 4.1: Added SDFM: Use Caution While Using SDFM Under Noisy Conditions usage note. ........................... 3
• Section 4.2 (Known Design Exceptions to Functional Specifications): Added Analog Bandgap References advisory. ..... 8
• Section 4.2: Updated Workaround(s) of Analog Trim of Some TMX Devices advisory.......................................... 9
• Section 4.2: Added ADC: Interrupts may Stop if INTxCONT (Continue-to-Interrupt Mode) is not Set advisory. ........... 10
• Section 4.2: Added ADC: DMA Read of Stale Result advisory.................................................................... 11
• Section 4.2: Added PLL: Power Down and Bypass May Take up to 120 SYSCLK Cycles to be Effective advisory. ...... 22
• Section 4.2: Updated SDFM: Dynamically Changing Threshold Settings (LLT, HLT), Filter Type, or COSR Settings Will
Trigger Spurious Comparator Events advisory....................................................................................... 24
• Section 4.2: Updated SDFM: Dynamically Changing Data Filter Settings (Such as Filter Type or DOSR) Will Trigger
Spurious Data Acknowledge Events advisory........................................................................................ 25
• Section 4.2: Updated Memory: Prefetching Beyond Valid Memory advisory. ................................................... 32
• Section 4.2: Added SYSTEM: Multiple Successive Writes to CLKSRCCTL1 Can Cause a System Hang advisory....... 37
• Section 4.2: Added During DCAN FIFO Mode, Received Messages May be Placed Out of Order in the FIFO Buffer
advisory. .................................................................................................................................. 41
• Section 4.2: Added Boot ROM: Calling SCI Bootloader from Application advisory. ............................................ 42
• Section 4.2: Added Boot ROM: Using CPU1 Wait Boot or CPU2 Idle Mode advisory. ........................................ 42
To Next Page
Loading...
