INS303-5 12/22
Installation
Remove all power from control panel before making any connections.
Install the SA840-A20 keypad in the required location and according to the1.
manufacturer’s instructions.
Program the SA840-A20 output format for Wiegand (format No 2).2.
Install the iProx module at least 0.5 metre away from other metal objects and3.
cables.
Connect the network connections of the module to the network connections4.
of the control panel.
Connect SA840-A20 keypad to the iProx as shown above.5.
Ensure that Options switch 1 is set to OFF (Internal Prox. Disabled) and6.
switches 2, 3 and 4 are set as required, (see chapter 3.1)
Using the Address switch set the address of the module to one of the7.
available remote keypad address slots, (see chapter 3.1)
Re-apply power to the control panel and select the engineer’s programming8.
mode.
Select the “Confirm Devices” option within the “Engineer Utils” menu and9.
confirm that the module is being “seen” as a remote keypad on the system.
If the relay on the iProx is utilized, it is controlled by the relevant keypad10.
output. Select the “Keypad Outputs” option within the “System Outputs”
menu and program it to the required type.
To Next Page
Loading...
