INS303-5 19/22
Installation
Remove all power from power supply before making any connections.
Install the 26bit Wiegand reader in the required location and according to the1.
manufacturers instructions.
Fix the iProx module at least 0.5 metre away from the 26bit Wiegand reader2.
and from other metal objects and cables.
Connect the +12V and 0V from the power supply to the + and - network3.
connections of the module.
Connect the optional devices such the, RTE button and speaker.4.
Ensure that Options switch 1 is set to OFF (Internal Prox. Disabled) and5.
switch 2 is set as required, (see chapter 6.2)
Ensure that Options switch 3 and 4 are initially set to OFF, (see chapter6.
6.2)
Re-apply power to the power supply.7.
Learn the 3rd party tags or cards (see below).8.
Check that the iProx and proximity tags operate correctly.9.
Learning 3rd Party Proximity Tags or Cards
To learn 3rd party tags or cards in stand-alone mode proceed as follows:
Set Options switch 3 to ON (Add Tag Mode), (see chapter 6.2)1.
Set Options switch 4 to ON (Program Mode), (see chapter 6.2) The status2.
LED will flash green when the module is in program and add tag mode.
To Next Page
Loading...
