INS884EN-4 20/87
Press n/n 4 and y/y for ComIP module.12.
The IP data should be entered for the ComIP com port of the SmartCom prior to
Com Port Setup (just like for Com-IP modules)
The data is uploaded to the SmartCom when the Com Port is changed from
'Nothing Fitted' to 'ComIP'.
It takes up to 45 seconds for the data to be uploaded to the SmartCom.
The SmartCom 4G can be returned to DCHP mode by clearing the IP data from the
panel com port and then changing the comport to 'Nothing Fitted' and then back to
'ComIP'. When the blank IP data is uploaded the SmartCom will automatically
switch back to DHCP mode.
IP addresses will only show for the ComIP com port. This is normal and correct.
Another way to revert back to DCHP mode is to use the new SmartCom 4G default
procedure.
To default SmartCom:
Remove SmartCom cover to create a tamper condition.1.
Press the Wi-Fi button 5 times within 3 seconds.2.
All four LEDs will flash for 10 seconds and then the SmartCom will reboot into3.
a default state.
WiFi
To enable a WiFi connection you will need access to the customers network SSID &
password. The SmartCom 4G will only function on networks with DHCP enabled.
The SmartCom 4G operates at 2.4 GHz supporting 802.11b/802.11g & 802.11n
wireless technology. 5GHz bands are not supported.
To Next Page
Loading...
Need help?
General
