Texi 1501 TS PREMIUM User Manual

11
Texi 1501 TS
C
o
m
pu
t
e
r
i
z
ed
E
m
b
r
o
i
d
e
ry
Mac
h
i
n
e
O
p
e
r
a
t
i
o
n
Ma
n
u
al
X/Y direction space: 0-±999.9mm
The control system takes mm as unit. Its numeric input value is 0.1mm
(0.1 mm = 1 mm) when inputting digits, i.e. if 100 mm space is needed,
the input value would be 1000 mm.
X/Y compensation (satin stitch): 0-±0.3
4.2-2 Switching Hoops
In design set interface, press key. The parameters from the design set box will
change into the different sizes of hoops, just as Fig. 6
Figure 6 Hoops Selection Box
Select current embroidery hoop type. When cap hoop or A-G hoops are selected, the
machine will search absolute origin (center) automatically, and stop at center of selected hoop.
Please pay attention to the hoop movement.
See Hoop Setting on embroidery range of cap hoop and A-G hoops. When using the “other”
hoop button the hoop will not automatically center. The embroidery range is also confirmed by
the software limits setting (See Software Limits Setting on detailed operation).
After selecting a hoop size, the screen goes back to “Design Set” interface automatically. If a
hoop type is not selected, the system will continue to use previously used hoop type
automatically.
After the cap hoop is selected, the currently selected embroidery design will be rotated 180°

Texi 1501 TS PREMIUM Specifications

General

Brand	Texi
Model	1501 TS PREMIUM
Category	Sewing Machine
Language	English