Texi 1501 TS PREMIUM - Part 4 Embroidery Design; 4.3-4 Offset Operation; 4.3-5 Return to Stop Point; 4.3-6 Set Color Changing Setting

13
Texi 1501 TS
C
o
m
pu
t
e
r
i
z
ed
E
m
b
r
o
i
d
e
ry
Mac
h
i
n
e
O
p
e
r
a
t
i
o
n
Ma
n
u
al
4.3-4 Offset Operation
In the embroidery process, if is required to return to the offset point. Press key
once and the hoop is moved to the offset point and will stop. Press the key gain, the hoop is
moved from the offset point to the starting point and stops, and then it can continue embroidering.
4.3-5 Return to Stop Point
In the embroidery process, after the hoop is moved manually, if it is required to return to the
stop position of embroidery machine. Press key to move the hoop to the stopping
point. After the key is pressed, it is moved to the stopping position automatically and stopped.
4.3-6 Set Color Changing Setting
The color changing setting includes color changing sequences and needle bar replacement.
In operation interface, press key to enter into color changing interface. Fig. 7
Figure 7 Color Changing Setting