14
4.3-6-1 Set Color Changing Sequence
In the color changing sequence to set the interface, press the number key to enter the color
changing sequence. Change the colors from 1-30 from the 1
st
page (the system supports a max of
200 colors change sequences). When the interface is opened for the first time with a new design,
the will start with color 1 and allow entry of the number of colors to match the design. Press the
number key and input the corresponding needle bar number of the color changing sequence for
the design. The cursor is moved to next color selection box automatically.
In the setting process, if a needle bar number has an error, click the selected number to reset
the value.
If there is no color changing sequence set, it uses the current needle bar to embroider.
If the color changing selection is not set, all colors will default to the last color sequence that
was input.
Upper value means current page, and lower value means max pages of
current embroidery design number. Left and right keys turn pages. However, max page turning
value cannot be larger than max pages of current embroidery design.
When the interface is opened for a design that has been previously setup, the cursor is started
from the last value position of needle bar automatically. Press the top left white box, in order to
move the cursor to the first color sequence and input the corresponding needle bar number of the
new color changing sequence. The cursor is moved to next color selection changing sequence
automatically. Press key to return to main interface.
4.3-6-2 Appliqué Offset, Low Speed Embroidering and Needle Bar
Replacement
If in a certain color change sequence, the offset mode is required or out of hoop (appliqué) at
the end of embroidery, press key once the letter “F” is displayed on the right hand
side of current needle bar number. Press key to cancel offset, out of hoop setting.
If a certain color change sequence requires deceleration for embroidery at the beginning of
embroidery (slow speed is set at “low embroidering speed” in “speed parameters” of embroidery
To Next Page
Loading...
Need help?
General
