PART 1 CONTROL SYSTEM 1
1.1 SYSTEM OVERVIEW 1
1.2 PRECAUTIONS 1
1.3 WORKING ENVIRONMENT 2
1.4 SYSTEM POWER SUPPLY AND GROUNDING 2
1.5 OPERATION PANEL AND KEY FUNCTION 2
1.5-1 Key Function Introduction 2
1.5-2 Icons Description of Touch Keys 2
1.5-3 Function 4
PART 2 EMBROIDERY DESIGN INPUT OPERATION 5
2.1 INPUT USB DRIVE DESIGN TO MEMORY 5
2.2 DELETE DESIGNS IN EMBROIDERY DESIGN MANAGEMENT 6
PART 3 SELECTING DESIGN IN EMBROIDERY DESIGN MANAGEMENT 7
3.1 SELECT EMBROIDERY DESIGN FOR EMBROIDERING 7
3.2 DELETE SINGLE EMBROIDERY DESIGN 8
3.3 OUTPUT EMBROIDERY DESIGN TO USB DRIVE 8
PART 4 EMBROIDERY DESIGN 9
4.1 EMBROIDERY STATUS MODE 9
4.2 PREPARATION STATUS 10
4.2-1 Set Embroidery Design Parameters 10
4.2-2 Switching Hoops 11
4.3 OPERATION STATUS 12
4.3-1 Embroidery Design Origin Setting (Starting Point) 12
4.3-2 Oset Point Setting (Highest Point of Hoop Center) 12
4.3-3 Return to Origin (Starting Point) 12
4.3-4 Oset Operation 13
4.3-5 Return to Stop Point 13
4.3-6 Set Color Changing Setting 13
4.3-6-1 Set Color Changing Sequence 14
4.3-6-2 Appliqué Oset, Low Speed Embroidering and Needle Bar
Replacement
14
4.3-6-3 Sequin Design 15
4.3-7 Change Color Sequence Mode 15
4.3-8 Embroidering Float Mode Switching 16
4.3-9 Embroidery Design Trace Operation 17
4.3-10 Returning to Embroidery Origin Point after Power Failure 17
TABLE OF CONTENTS
To Next Page
Loading...
Need help?
General
