110
After your changes have been made, click Apply to confirm any modifications.
Once changes are applied, the associated information will be updated on the
Stack Target List window.
D. Stack Target ACL
Go to the System Folder section with associated Device Folder created by NAS
stacking. The ACL settings will be exactly the same as the system folder that you
may have setup previously.
E. Reconnect a Stack Target
This is used to enable stack target devices that may have been disconnected due
to a power outage or a disconnected network. When this happens, the
Reconnect button will become available. To attempt to reconnect the stack
target, click Reconnect.
To Next Page
Loading...
Need help?
General
