Thecus N2810 Series - Link Aggregation

51
Link Aggregation
The Thecus IP storage supports link aggregation from on board network port .
Simply click on Add from Link Aggregation page and the screen will appear as
below.
Click on field of “Link Aggregation Combination Device” to select member for Link
Aggregation. Also fill in all other required information to complete the setting.
Link Aggregation Configuration
Jumbo Frame Support
Enable or disable Jumbo Frame Support of the associated
interface on your Thecus IP storage.
Aggregation Mode
Select from drop down list for desired mode.
IPv4/IPv6
Click to enable IPv4/IPv6 for TCP/IP. The default is IPv4
enabled.
Mode
It has to be a static IP with the link aggregation being used.
IP
IP address of link aggregation.
Netmask/Prefix Length
Input netmask for IPv4 and Prefix length for IPv6.
Gateway
Gateway for associated link aggregation
Click Apply to confirm the setting. The newly created Link Aggregation will
appear on associated device list