Thecus N2810 Series User Manual

49
Basic Setting
MAC address
MAC address of the network interface.
IP
IP address of associate NIC interface.
Device speed
Display associated NIC port link speed.
Link status
Display associated NIC port link status.
Jumbo Frame
Input Jumbo Frame rate from drop down list, default is 1500
Note
Input the description of associated network port if any
IPv4/IPv6
Setting IP address from manual input or DHCP server .
Mode
It can choose a static IP by manually input or Dynamic IP from DHCP
server.
IP address
Input IP address if manually input has selected or displayed by granted
from DHCP server
Netmask
Input netmask if manually input has selected or displayed by granted
from DHCP server
Gateway
Input gateway if manually input has selected or displayed by granted from
DHCP server
DHCP Server:
The network port of Thecus IP storage can be acted as DHCP server if associated
NIC has been set-up to a static IP. Please fill in the fields to complete setting.
DHCP Configuration
Item
Description
Enable IPv4/IPv6 DHCP
Server
Enable or disable the IPv4/IPv6 DHCP Server to automatically
assign IP address to PCs connected to associate NIC
interface.
Start IP (IPv4)
Specifies the lower IP address of the DHCP range.
End IP in (IPv4)
Specifies the highest IP address of the DHCP range.
WARNING
Most faster Ethernet (10/100) Switches/Routers do not support Jumbo Frame and will not be
able to connect to your Thecus NAS after Jumbo Frame is turned on.
NOTE
• Only use Jumbo Frame settings when operating in a Gigabit environment
where all other clients have Jumbo Frame Setting enabled.
• Proper DNS setting is vital to networks services, such as SMTP and NTP.

Thecus N2810 Series Specifications

General

Brand	Thecus
Model	N2810 Series
Category	Server
Language	English