98
To change the state of enabled Disk-Security disk, click on associated disk (MUST
in unused) and the available function tab will appear.
Other than Set Password as mentioned above, the Disk Security can be disabled
by clicking on ‘Disable Disk Security” and the disk can be erased by clicking on
“Erase Disk” if correct password has been inputted.
iSCSI
You may specify the space allocated for iSCSI. See the table below to view the
allowed iSCSI target number per system:
The disk to enable Disk-Security setting is
only available while disk is unused
The USB disk which has contained password
need to plug-in on system once associated
disk with Disk-Security enabled is part of
RAID member during system power on.
Without enable Disk-Security on installed
disk, it is just like normal disk
To Next Page
Loading...
Need help?
General
