146
From “iSCSI” tab click on Add button and the setting screen will appear as below.
Follow the steps to complete the setting.
1. Fill in the remote target IP (Destination) and port (need to be changed only if
this port is already in use). If encryption is required then enable it. Please
make sure the associated target server also has encryption enabled. And
click on “Get Server Folder” to get remote target server folder list to choose
destination.
2. System will list available iSCSI volume, choose source iSCSI volume to
backup. The multiple iSCSI volume selection is allowed.
To Next Page
Loading...
Need help?
General
