88
8. Specify a stripe size — 64K is the default setting.
9. Specify size for “Bytes per inode” if ext3/ext4 has selected. The default
value is Auto and it has no need to change for general use.
10. Select the file system you would like to have for this RAID volume. The
selection is available from ext3, XFS, ext4 and btrfs.
11. Press Create Finished to build the RAID storage volume.
RAID Level
You can set the storage volume as JBOD, RAID 0, RAID 1, RAID 5, RAID 6,
RAID 10, RAID 50 and RAID 60 (Depend on Model and how many disks
has been installed).
Building a RAID volume may be time consuming, depending on the size
of hard drives and RAID mode. In general, if the RAID volume building
process is up to “RAID Building”, then the data volume is accessible.
To Next Page
Loading...
Need help?
General
