Next, input the target IP address of the stackable device and click the Discovery
button. The system will list available target volumes from the inputted IP address.
Once IP with volume have been set, you may need to input a valid user name and
password to validate your access rights. If there is no user name and password
needed to access target volume, then leave it blank.
Once IP with volume have been set, you may need to input a valid user name and
password to validate your access rights. If there is no user name and password
needed to access target volume, then leave it blank.
The Export share name will become the network share name and displayed
through network access such as SMB. You may refer the figures below to see the
result. Please note the naming limitation.
72
To Next Page
Loading...
Need help?
General
