Read and understand this entire manual and your employer’s
safety practices before installing, operating, or
servicing the equipment.
While the information contained in this manual represents our
best judgement, Thermal Dynamics Corporation assumes no
liability for its use.
DRAG-GUN Plasma Cutter Operating Manual
Number 0-2682
Published by:
Thermal Dynamics Corporation
Industrial Park No. 2
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
Copyright 1998 by
Thermal Dynamics Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written
permission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liabil-
ity to any party for any loss or damage caused by any error or
omission in the DRAG-GUN Plasma Cutter Operating Manual,
whether such error results from negligence, accident, or any
other cause.
Printed in the United States of America
April 2000
WARNING
WARNING
To Next Page
Loading...
Need help?
General
