Thermo Scientific TSX Series Installation And Operation Manual

8 | Operating Standards Ultra Low Temperature Freezers
Operating Standards
The freezers described in this manual are classified for use as
stationary equipment in a Pollution Degree II and over voltage
Category II environment.
These units are designed to operate under the following
environmental conditions:
• Indoor use.
• Altitude up to 2000 m.
• Maximum relative humidity 60% for temperatures within
15 °C to 32 °C (59 °F to 90 °F).
• Main supply voltage fluctuation shall not exceed ±10% of
the nominal voltage. For the 100V input condition this
should be +10% and -8%.
• For the TSX series, the ULT should not be connected to a
GFCI (Ground Fault Circuit Interrupter) protected outlet as
it may be subject to nuisance tripping.
Electrical Specifications
The data plate identifies the electrical specifications and
current ratings for your unit.
Note: Specified voltage range implies the input voltage is a
standard global voltage.
Table 1. TSX Series Electrical Specifications
Model Voltage Frequency Current
TSX40086FA
100-230 V 50/60 Hz 8.9-4.9 A
TSX40086LA
TSX50086FA
TSX50086LA
TSX60086FA
TSX60086LA
TSX70086FA
TSX70086LA

Thermo Scientific TSX Series Specifications

General

Type	Laboratory Refrigerator
Cooling Type	Forced air cooling
Defrost Type	Automatic
Door Type	Solid or glass door options
Controller Type	Microprocessor
Certifications/Compliance	UL, CE
Energy Consumption	Varies by model; refer to product specification sheet
Voltage	115V
Exterior Dimensions (H x W x D)	Varies by model; refer to product specification sheet
Interior Dimensions (H x W x D)	Varies by model; refer to product specification sheet
Weight	Varies by model; refer to product specification sheet
Shelves	Adjustable shelves
Energy Efficiency	Energy Star certified models available