Orion Benchtop pH/ISE Meter Instruction Manual
Overview of Meter Functions-420Aplus, 710Aplus
98
Code Function Description
5-2 SET PRINT Sets the timed print interval. The maximum
print INTERVAL is 23 hours, 59 minutes,
and 59 seconds. The minimum print interval
is 5 seconds. When the code 5-2 is displayed
in the lower field, the current print interval
hours will flash in the main display.
Press yes or press or to change, then
press yes. For the print interval minutes:
seconds will be displayed in the main field.
Press yes or change, then press yes. The
default setting is 1 minute.
The following set-up modes apply to the 710Aplus model only:
6-1 DATA- Sets the datalogger mode. Up to 25 points
LOGGERS may be stored in mode memory at any one
time. When the code 6-1 is displayed in the
lower field the current datalogger mode will
flash in the main display. Use or to
change, then press yes.
The four options are:
0 Off, when 0 is selected no
datalogging of any kind will take place.
1 Manual datalog, no automatic output
to the datalogger will occur, the user
may datalog on command by pressing
2nd then print.
2 Datalog on READY, datalogging occurs
when the electrode signal is stable.
3 Datalog on a timed interval. Datalogging
occurs at user selected intervals. The
default setting is 0: OFF.
▼
▼
▼
▼
To Next Page
Loading...
Need help?
General
