Page 25 of 29 Revision 3.3 Feb 2021
ProReact EN Analogue Installation Manual
Document Ref. PACC-MAN
Re-commissioning the ProReact EN Analogue Control Unit
To reset the ProReact EN Analogue Composite Control Unit, press and
hold the SET and SELECT buttons in normal operation for 15s (during
which time the power light will ash quickly). The unit will reset and the
display will show “Self Program? Correct? No”.
The commissioning procedure can be carried out once again by cycling
through the screens using the SET and SELECT buttons. See the section
“Commissioning” for more information. The chosen values from the
previous setup will be presented by the control unit at each point during
the commissioning procedure.
Once the screen shows “Self Program? Correct? No” the
settings have been erased and the control unit requires
re-commissioning to return to normal operation.
To Next Page
Loading...
