To Next PageTo Next Page
Need help?Do you have a question about the Thermocable ProReact EN Analogue and is the answer not in the manual?
Essential recommendations and requirements to follow before commencing installation.
Overview of the system's parts and general functionality.
Explains how ambient temperature and cable resistance affect alarm activation.
Details the system's ability to detect rapid temperature increases.
Lists available pre-alarm temperature settings for early warnings.
Guidance on matching settings to typical and maximum ambient temperatures.
Guidance on secure wall mounting of the main control unit.
Instructions for affixing the end-of-line unit to a surface.
Recommended sensor cable spacing based on fire safety standards.
Details control unit wiring, remote reset function, and Modbus communication.
Specific advice for installing the system in hazardous environments.
Guidance on using leader cables and managing installation in cold conditions.
Procedures for joining multiple lengths of analogue linear heat detection cable.
Steps for initial setup, including programming and calibration resistance entry.
Procedures for entering and verifying sensor cable codes and zone lengths.
How to select and configure alarm and pre-alarm temperature settings.
Understanding system status through diagnostic screens and LED indicators.
Explains fault conditions, error codes, and corresponding LED signals.
Identifies triggers for alarms, including rate-of-rise and ambient temperature.
Details methods to clear alarms and return the system to normal operation.
Procedures for testing the control unit and the overall functional integrity of the LHD system.
General| Brand | Thermocable |
|---|---|
| Model | ProReact EN Analogue |
| Category | Security Sensors |
| Language | English |
