Thermocable ProReact EN Analogue - Table of Contents

Page 4 of 29 Revision 3.3 Feb 2021
ProReact EN Analogue Installation Manual
Document Ref. PACC-MAN
Contents:
Important - Read before commencing installation Page 5
General Overview Page 6
Theory of Operation Page 7
Alarm temperatures
Pre-alarm temperatures
Application temperatures
Technical Specications Page 10
ProReact EN Analogue Composite Control Unit
ProReact EN Analogue End-of-line Unit
ProReact EN Analogue Sensor Cable
Mounting instructions Page 14
ProReact EN Analogue Composite Control Unit
ProReact EN Analogue End-of-line Unit
ProReact EN Analogue Sensor Cable
Area Protection Page 16
Control Unit Wiring Page 17
Remote Reset
Modbus RS-485 RTU/ASCII
Hazardous Area Installation
Typical System Wiring Page 18
Useful information Page 19
Leader Cable
Low Temperature Considerations
Joining Sensor Cable
Commissioning Page 20
Normal Operation
Fault conditions
Alarm conditions
Resetting the control unit after an alarm condition
Testing and Verication Page 24
Re-commissioning the ProReact EN Analogue Composite Control Unit Page 25
Glossary Page 26
Appendix A - Alarm Temperature Charts Page 27