thomann DP-28 Plus - 7 Sound Selection and Layering; Selecting and Switching Sounds; Setting Up Layer Mode

7.9 Selecting sounds
The digital piano has a total of 25 sounds that can be called up using the [PIANO] /
[EP] / [KEYBOARD] / [SYNTH] / [OTHER] buttons (see Ä Chapter 8 ‘Sound list’
on page 31).
1. Press one of the [PIANO] / [EP] / [KEYBOARD] / [SYNTH] / [OTHER] buttons to
select a sound group.
ð
The LED of the selected button lights up.
2. Press the key of the selected sound group repeatedly to determine a desired
variation sound in it (see Ä Chapter 8 ‘Sound list’ on page 31).
3. To select a dierent sound group, press again one of the [PIANO] / [EP] /
[KEYBOARD] / [SYNTH] / [OTHER] buttons .
7.10 Layer mode and split point
7.10.1 Setting the Layer mode
With the layer mode you can set the "layering" of sounds.
1. Hold down one of the [PIANO] / [EP] / [KEYBOARD] / [SYNTH] / [OTHER] buttons
and then press another one for the layer (e.g. [PIANO] and [SYNTH]) to activate
the layer mode.
ð
The LEDs of the selected buttons light up.
2. Press the selected keys (e.g. [PIANO] and [SYNTH]) repeatedly to set a desired
variation sound for the selected sound groups (see
Ä Chapter 8 ‘Sound list’
on page 31).
3. Hold down [SHIFT] and press the piano keys [A7] or [A#7] to set the octave shift
for the layer tone (SOUND R2).
4. Hold down [SHIFT] and press the piano keys [G7] or [G#7] to set the volume for
the layer tone (SOUND R2).
5. To deactivate the layer mode, hold down the button whose sound you want to
switch o (e.g. [SYNTH]) until the LED goes out.
ð
The Layer mode is deactivated.
6. To reactivate the layer mode, proceed as described in step 1.
Switching on / o and basic operation
DP-28 Plus
19