54 HA0363T Rev D Jan 2017
Chapter 6
Persist Settings to Hardware - Many of the parameters that can be set for the DC
Driver K-Cube can be stored (persisted) within the unit itself, such that when the unit
is next powered up these settings are applied automatically. This is particularly
important when the driver is being used manually in the absence of a PC and USB
link. The Stage and Homing parameters described previously are good examples of
settings that can be altered and then persisted in the driver for use in absence of a
PC. To save the settings to hardware, check the ‘Persist Settings to Hardware’
checkbox before clicking the ‘OK button.
6.3.3 Servo Loop Tab
Fig. 6.5 DC Driver K-Cube - Advanced Settings
Caution
The ‘Persist Settings’ functionality is provided to simplify use of the unit
in the absence of a PC. When the unit is connected to a PC and is
operated via APTUser, the default APTServer settings will be loaded at
boot up, even if the ‘Persist Settings’ option has been checked.
To Next Page
Loading...
General