THORLABS ORIC PDXC2 - Connecting to Kinesis Software; USB Connection Guide; Ethernet Connection Guide

PDXC2 ORIC® Piezo Stage Controller Chapter 3: Software
Page 10 CTN015391-D02
Connect PDXC2 to Kinesis Software
3.2.1 Connect by USB Cable
The USB Type-B connector is located at the back panel of the PDXC2 controller. After the PDXC2 has been
connected to PC by USB-Cable, Kinesis software can access the PDXC2 device as in figure 13.
Figure 13 Connect PDXC2 by USB Cable
3.2.2 Connect by Ethernet Cable
The Ethernet connector is located at the back panel of the PDXC2 controller. The PDXC2 will obtain the IP address
through the DHCP server. The Kinesis software can access the PDXC2 device as shown below in figure 14. Scan for
the PDXC2 device first, and then wait about 10-20 seconds, the PDXC2 will be found and can be connected.
Figure 14 Connect PDXC2 by Ethernet Cable
1
2
3
1
2
3
4
5
6