THORLABS ORIC PDXC2 - Stage Connections and Accessories; Front Panel Overview

PDXC2 ORIC® Piezo Stage Controller Chapter 2: Overview
Page 4 CTN015391-D02
DB15 port for connecting
to stages with encoders
like PDX1(/M) or to stages
with a SMC input such as
PD1(/M) using the
PDXC2AD adapter cable.
Stage Connections and Accessories
Figure 4 shows how the stages are connected to the PDXC2 controller. The DB15 connector connects with the
ORIC® Piezoelectric Inertia Drive Stages with Optical Encoders (i.e. PDX1(/M)) or connects with stages which have
a SMC connector (i.e. PD1) through the PDXC2AD DB15 to SMC adapter cable.
Figure 4 Connections Between Stages and PDXC2
The section below lists the connection components and accessories packed along with this controller. The PDXC2
controller is equipped with and powered by the DS12 12 V AC/DC adapter, which is compatible with 100 - 240 VAC,
50 - 60 Hz power sources.
Shipped Connectors
• Ethernet Cable: 2 m, Male Cat5e Connector to Male Cat5e Connector
• I/O Cable: 0.5 m, Female 9-Pin D-Sub Connector to 4 Male BNC Connectors
• USB Cable: 2 m, Male Type A Connector to Male Type B Connector
• Power Supply Cable: 1.5 m, Male NEMA 5-15-P Connector to Female IEC 320 C13/C14 Connector
• DS12 12 VDC Power Adapter: 1.23 m, M8, 4-pin female connector, input range 100 - 240 VAC, 12 VDC
output
2.3.1 Front Panel
Figure 5 PDXC2 Front Panel
DB15 port for connecting
to stage with encoder like
PDX1(/M) or connecting to
stage without encoder like
PD1 through PDXC2AD.
DB15 port for connecting
to stage with encoder like
PDX1(/M) or connecting to
stage without encoder like
PD1 through PDXC2AD.
F1
F2
F3
F4
1