PDXC2 ORIC® Piezo Stage Controller Chapter 3: Software
Rev A, July 25, 2023 page 15
Figure 17 Move Setting Panel
2. Enter the required absolute position and/or parameter values.
3. To move to the position entered click the arrow.
3.4.3 Stopping the Stage
During operation, the stage can be stopped at any time by clicking the ‘Stop’ button on the GUI panel. The
PDXC2 remains powered after clicking the ‘Stop’ button.
3.4.4 Jogging
During PC operation, the motor actuators are jogged using the GUI panel arrow keys. There are two jogging
modes available for closed loop mode and open loop mode, ‘Single Step’ and ‘Continuous’. In ‘Single Step’
mode, the motor moves by the step size specified in the Step Size parameter. If the jog key is held down, single
step jogging is repeated until the button is released. In ‘Continuous’ mode, the motor actuator will accelerate
and move at the Step Rate/Speed parameter while the button is held down.
Figure 18 Jog Setting Panel
Jog move operation steps:
1. Click Settings Button to set Jog Parameters as required, then click OK button to apply parameters.
Jog Controls arrow. 2. Start move by clicking
To Next Page
Loading...
