PDXC2 ORIC® Piezo Stage Controller Chapter 1: Safety
Rev A, July 25, 2023 Page 1
Chapter 1 Safety
All statements regarding safety of operation and technical data in this instruction manual will only apply when the
unit is operated correctly in accordance with this user manual.
Warning: Risk of Electric Shock
High voltage inside. To avoid electrical shock, before powering up, make sure that the ground
pin of the power cord is correctly connected to the ground connector in the power socket.
Improper grounding can cause electric shock resulting in severe injury or even death. Do not
operate without the cover installed.
Warning: Risk of Electric Shock
The maximum current output for the piezo stage is 10 A, and the D-Sub connector does not
support hot plugging. Plugging or unplugging the connector while the unit is powered on can
cause damage to the stage and/or controller.
Caution: Do Not Open Housing
The PDXC2 has no user-serviceable parts. Service should only be performed by trained service
personnel.
For all applications, use an IEC320 compatible power cord fitted with a plug appropriate for your particular power
socket. Make sure that the line voltage rating marked on the power adapter agrees with your local power supply.
Warning: Risk of Explosion
This unit must not be operated in explosive environments.
Warning: Components not Water Resistant
This unit should not be used in wet/damp conditions. Additionally, do not obstruct the air
ventilation slots in the housing!
To Next Page
Loading...
