PDXC2 ORIC® Piezo Stage Controller Chapter 3: Software
Rev A, July 25, 2023 page 19
Figure 24 Two GUI Instances for Raster Scan
Switch both GUI instances to closed-loop operation and home all the devices; the home logo should turn green
when completed. Then switch the Trigger Mode as follows in the settings panel on the bottom right of the GUI:
• Configure device 1 (the top GUI in Figure 25 below) to be Fixed Step Size mode, defining the step size (0.5
mm).
• Configure device 2 (the bottom GUI in Figure 25 below) to be Fixed Positions mode, defining the two
positions with their own edge type (5 mm in rising edge for Position 1 and -5 mm in rising edge for Position
2 in this example).
Figure 25 Switch Both Devices to Trigger Mode
With all these settings done, press the Move or Jog Step button in closed-loop operation, which will start this Scan
motion. The operation will run until one device runs out of range and stop automatically. During this scan, you
can see Device 1 move at step distance each time Device 2 finishes a motion back and forth.
To Next Page
Loading...
