-36-
SETTING UP MAIN ROTOR COLLECTIVE PITCH ANGLE / 主旋翼螺距設定
Since you have been setting the lengths of the pushrod as mentioned, the linkage should be centered well as
described below.
若您依照前述設定連桿長度，連桿位置將如下述。
Maximizing
1. Place the collective stick at high end.
2. The main blades should be at 10 degree and
the swashplate should be level.
Minimizing
1. Place the collective stick at low end.
2. The main blades should be at 10 degree and the
swashplate should be level.
NOTE:
1. The steps above define the limits of the collective
pitch setting.
2. The setting of the maximum collective pitch
depends on your personal flying skill and style.
Too much collective pitch could overload the ESC,
motor and the battery. And it will reduce the flying
time also.
0°
-10°
-10°
Centering
1. The levers should be as the drawing below while
centering the collective pitch stick.
2. Parallel the flybar, the main blades should be at 0
degree and the swashplate should be level.
中立點
1. 發射機撥桿置於中立點時，升降舵與副翼面應呈現水平狀
態（如圖示）
2. 平衡片與主旋翼應呈現平行狀態（0°），十字盤呈現水
平。
最大設定角度
1. 將螺距撥桿上推至最高點。
2. 主旋翼相對於平衡桿角度為10°，十字盤呈現水平。
最小設定角度
1. 將混控撥桿下推至最低點。
2. 主旋翼相對於平衡桿角度為-10°，十字盤呈現水平。
注意事項
1. 上述步驟為主旋翼螺距設定範圍。
2. 最大設定角度依照您個人的飛行技巧與習慣而定，過大
的角度將容易導致速控器、馬達與電池發生過載現象，亦
會縮短飛行時間。
To Next Page
Loading...
Need help?
General
