TIC TR-220 - Shipping and Packing the Test Set

Rev E TR-220 90 008 088-1
1-4
• RMA Form on top of the product
• The assigned RMA number written in bold letters on the
outside of the shipping container
• Model, Serial Number, and specific details regarding the
problem
• POC name, return address, telephone number, and
email address
5. Freight Charges to the factory are the responsibility of the owner/operator.
Tel-Instrument will provide return shipping if the problem is determined to be
warranty covered.
1.4.2 Shipping and Packing the Test Set
1. Repackage the Test Set in the Original container utilizing the provided
packing material. Do Not Ship the Test Set with out using a shipping
container, this will prevent damage to the case and or finish during transit.
2. Wrap the Test set within plastic sheeting and firmly seat the Test Set in
the original corner molds. Place all necessary documentation (RMA Form,
POC, etc…), on top of the Test Set.
3. Utilize Package Tape and seal all seams. If the use of an industrial box
stapler is used, be sure that they do not protrude through the box to
prevent injury to personnel handling the package.
4. Firmly affix a shipping label and mail the Test Set to the following:
Tel-Instrument Electronics Corp.
728 Garden Street
Carlstadt, NJ 07072
Attn: Repair Department