5--9
34
" open the vice by rotating the handwheel anti---clockwise and position the
workpiece between the jaws.
" Bring the moveable jaw to within 2÷3 mm of the workpiece by rotating the
handwheel clockwise.
2 --- 3 m m
" Block the piece by means of the pneumatic cutting vice block, by pressing the
close cutting vice button.
" Check that the workpiece is effectively locked in positon!
If the vice was already closed by the pneumatic piston, it may not block the
piece. In this case it is necessary to repeat the operation, i.e.: open the vice by
pressing the specific button, bring the moving jaw near to the piece and block
it again with the closing button, bearing in mind that the stroke of the pneuma-
tic piston is approx. 6 mm.
Cutting stroke adju stment
" Once the workpiece is locked in position, the cutting stroke must be adjusted.
When the head down button is pressed, the cutting head is automatically low-
ered.
N.B.
To Next Page