MEP S.p.A.
5--10
35
Use and maintenance manual TIGER 370 CNC--MR
" Keep the button pressed until the disk is at 5/10 mm from the material to be
cut.
" Memorize the FCTI (Head Upstroke Limit) by pressing the specific button;
" after pressing the FCTA memorizing button, the display will indicate that it
has been memorized.
SEMI-AUTOMATIC
X=
θ° =
W=
F = 153
S=
kg= 10
DL= 0
SL= 3
AM= 0.0
A = 0.1
T= 0:0
TT= 0:10
CURRENT CYCLE
F9 = MAIN MENU
F5 = RESET TT
FCTI
" The FCTI (Head Downstroke Limit) will be restored at the end of the cut.
Preparing to cut
" Select the fluid for automatic operation by pressing the specific button. The
led of the relative button will light up.
" Adjust the head descent speed potentiometer to 0 to avoid undesirable start-
ing speeds.
Cutting
" Close the protection and press the reset button;
" Enable motor rotation by activating the blade motor selector on the control
console;
To Next Page