TiLite
®
OM000007 - Rev. B
47
installed.
Removing Rigid Side Guard Assembly
Tools Needed:
• 3/16” Allen Wrench
To remove the entire side guard assembly, including
the side guard clamp:
1. Remove the side guard from the side guard mount.
2. Remove the Allen Screw that secures the two
halves of the side guard clamp to the frame. See
Figure 52.
Reinstalling Rigid Side Guard Assembly
Tools Needed:
• 3/16” Allen Wrench
1. Align the two halves of the side guard clamp around
the seat tube of the chair frame. See Figure 52.
Note: On all chairs other than ZR Series and Aero Z
chairs, the half of the side guard clamp to which the
side guard mount is attached has a dowel pin
protruding from the clamp that must be inserted in
the side guard clamp hole in the frame. On ZR
Series and Aero Z chairs, the side guard mount
belongs on the outside of the frame.
2. Insert the Allen Screw into the two halves of the side
guard clamp and securely tighten.
3. Insert the side guard bracket into the side guard
mount and adjust the two Allen Screws as described
under “Adjusting Rigid Side Guards” on page 46.
Fold-Down Rigid Side Guards
(Standard and Carbon Fiber)
(YG Series, ZR Series, Aero Z, TR, YR and Evo)
Using Fold-Down Side Guards
The fold-down side guards utilize an internal spring.
To fold down, simply remove the seat cushion and
push the top of the side guard toward the seat sling.
To unfold, simply pull the side guard up away from the
seat sling. See Figure 53.
Removing the Fold-Down Side Guard
Assembly
Tools Needed:
• 3/8” Allen Wrench
1. Remove the two Allen Screws that secure the two
Figure 52
Removing/Replacing Side Guard
Assembly
Side
Guard
Mount
Dowel
Pin
Side
Guard
Clamp
Side Guard
Clamp Hole
Allen
Screw
Figure 53
Fold-Down Rigid Side Guards
Side
Guard
Clamp
Allen
Screw
Side
Guard
Hinge
Side
Guard
Bracket
To Next Page
