TIMBERWOLF
TW 150DHB
11
BEFORE USING THE CHIPPER
STARTING THE ENGINE
STOPPING THE ENGINE
OPERATING INSTRUCTIONS
ENSURE throttle lever is in the slow (tortoise) position.
INSERT key. Turn to heat.
HEATER LED comes on.
WAIT FOR HEATER LED TO GO OUT.
TURN key to engage starter motor.
RELEASE key once engine starts.
0
1
2
HOURS
0
0
0
0
0
0
0
HOURS COUNTER
START
HEAT
OFF
ON
0
1
2
Do not engage starter motor for more than 20
seconds - allow one minute before attempting to
start. Investigate reasons for failure to start.
ROTATION
1. Slacken nut using
integral handle.
2. Rotate tube.
3. Retighten nut.
1
DISCHARGE CONTROLS
Controlling the discharge is an essential part of safe working.
BUCKET ANGLE
4. Adjust the bucket to the desired
angle using the handle provided.
MOVE the throttle lever to the ‘Tortoise’ to reduce the engine speed to idle.
LEAVE the engine running for 1 minute.
TURN the power switch to position 0. The engine should stop after a few seconds.
REMOVE the ignition key.
For more detailed information refer to the Engine Owner’s Manual
3
6
4
5
7
1
2
PRESS THE GREEN
BUTTON
THE ROLLERS
SHOULD TURN FORWARDS
PRESS THE RED
SAFETY BAR
THE ROLLERS
SHOULD STOP
PRESS THE BLUE BUTTON
THE ROLLERS SHOULD TURN
BACKWARDS ONLY WHILE THE
BUTTON IS PRESSED
PRESS THE GREEN
BUTTON AGAIN
THE ROLLERS SHOULD
TURN FORWARDS
PRESS THE EMERGENCY
RED BUTTON
THE ROLLERS
SHOULD STOP
PRESS THE BLUE BUT-
TON
THE ROLLERS SHOULD
NOT TURN
PULL TO RESET
THE RED BUTTON
THE MACHINE IS
READY TO USE
WITH THE ENGINE RUNNING AT FULL SPEED
To Next Page
Loading...
