TIPTEL 3240 - 4.6.2. Static IP Mode; 4.6.3. PPPoE Mode

4.6.2. Static IP Mode
1. In the LAN Port interface, press the Up or Down key on the phone keyboard to select Static
IP, then Press the OK key on the phone keyboard or the Enter soft key to enter Static IP
Setting interface and input IP address.
2. Press the Down key on the phone keyboard to enter the Subnet Mask of Static IP Setting
and input the subnet mask.
3. Input the IP address, Subnet mask, Gateway, DNS 1 and DNS 2 in the corresponding area,
Press the OK key on the phone keyboard or the Save soft key to save.
4.6.3. PPPoE Mode
1. In the LAN Port interface, press the Up or Down key on the phone keyboard to select
PPPoE, then Press the OK key on the phone keyboard or the Enter soft key to enter PPPoE
Setting interface.
2. Press the Up or Down key on the phone keyboard to enter User Name, Password:
3. In according areas input User Name, Password;
4.6.4. Configure PC Port Mode
1. In the Network Settings interface, press the Up or Down key on the phone keyboard to
select PC Port, press the OK key on the phone keyboard or the Enter soft key to enter PC Port
configuration interface：
2. In the PC Port configuration interface, press the Up or Down key on the phone keyboard to
select Bridge mode or Routing mode:
3. Configured Bridge mode, there will pop-up “Reboot Phone”；Press OK key to reboot（PS：
Setting will take effect after reboot）
4. If cancel the reboot, the Settings will be saved but not take effect；
5. Configured Routing mode, enter routing setting interface, input according value in the
corresponding position;
6. Press Save key after configuration, the phone will reboot；
4.6.5. Configure VLAN
In the Network Settings interface, press the Up or Down key on the phone keyboard to select
VLAN Port, press the OK key on the phone keyboard or the Enter soft key to enter LAN Port
configuration interface：
LAN Port
1. In the LAN Port interface, press the Up or Down key on the phone keyboard to select LAN