: LLDP stands for Link Layer Discovery Protocol, it’s used
to exchange device information between any two
directly-connected devices. LLDP is often used to configure
Voice Vlan automatically for IP phone.
To display and configure Local RTP settings.
Max RTP Port: Determine the maximum port that RTP
Min RTP Port: Determine the minimum port that RTP
stream can use.
To display and configure SNMP settings.
Active: To enable or disable SNMP feature.
Port: To configure SNMP server’s port.
Trusted IP: To configure a
llowed SNMP server address, it
could be an IP address or any valid URL domain name.
Note
: SNMP (Simple Network Management Protocols) is
Internet-standard protocol for managing devices on IP
networks.
To display and configure VLAN settings.
LAN Port/PC Port: You can configure VLAN setting for
both ports respectively.
Active: To enable or disable VLAN feature for designated
port.
Vid: To configure VLAN id for designated port.
Priority: To select VLAN priority for designated port.
Note
: Please consult your administrator for specific VLAN
settings in your networking environment.
To display and configure QoS settings.
SIP QoS: To configure QoS value for all SIP message.
Voice QoS: To configure QoS value for all audio
stream(RTP streams).
To display and configure TR069 settings.
Active: To enable or disable TR069 feature.
Version: To select supported TR069 version (version 1.0
or 1.1).
ACS/CPE: ACS is short for Auto configuration servers as
server side, CPE is short for Customer-premise
equipment as client side devices.
URL: To configure URL address for ACS or CPE.
User name: To configure username for ACS or CPE.
Password: To configure Password for ACS or CPE.
Periodic Inform: To enable periodically inform.
Periodic Interval: To configure interval for periodic
inform.
To Next Page
Loading...
