It may be useful to set limits to the movement scope of the dish for easier ma-
nipulation. Repeat these steps two times to set a limit position for the east and
the west.
1. Choose Go to Reference from Positioner Command for the dish to return
to the reference point.
2. Place the focus on Move and press the left or right navigation button to drive
the dish.
3. Choose Set East (soft) Limit or Set West (soft) Limit from Positioner Com-
mand to save the dish’s current position to use it as a limit position.
Choosing Disable (soft) Limits from Positioner Command clears these limit po-
sitions.
Using USALS
Open the Settings > Installation > Positioner Setting menu. Set Positioner to
USALS and then specify these items correctly:
• Dish Longitude: Enter the longitude where the dish is located.
• Dish Latitude: Enter the latitude where the dish is located.
Give the dish a test run to see if it works properly. Repeat these steps for every
desired satellite.
1. Choose Go to Reference from Positioner Command for the dish to return
to the reference point.
2. Choose Satellite and choose a target satellite.
3. Choose Frequency and select any available transponder.
4. Choose Go to to rotate the dish so that it faces the target satellite.
3.3 Scanning for Satellite TV Channels
Open the Settings > Installation > Service Search menu.
Three methods are available to scan for satellite TV channels.
S C 23
To Next Page
Loading...
