Toa VM-3240VA - Creating Remote Microphone Name Labels; Inserting the Name Label

72
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Name label entry slit
[RM-200M]
Name label B*
Name label A*
* Created and printed using the VM-3000 Setting Software.
12.2. Creating Remote Microphone Name Labels
Using the VM-3000 Setting Software function, assigned names of preset RM-200M Function keys can be
printed out. Once printed, cut out the printed names with scissors to use them as corresponding name labels.
The paper used for the name label must be under 0.2 mm in thickness.
Note
For creating and printing name labels using the VM-3000 Setting Software, see the separate Setting Software
Instructions, "Labels for Remote Microphones."
12.2.1. Inserting the name label
• Fully insert the name label cut to the instructed size into the label entry slit.
• To remove the label, pull it out of the slit using the tip of knife blade.