TOHATSU BFT 150D - Trimming the Outboard Motor

65
OPERATION
The BFT150D is equipped with the
power trim/tilt system which can
adjust the outboard motor angle (trim/
tilt angle) while cruising and
mooring. The outboard motor angle
can also be adjusted while cruising
and accelerating to obtain the
maximum speed and optimum
driveability and fuel economy.
Press either UP or DN (down) of the
power trim/tilt switch and tilt the
outboard motor to the best position in
compliance with the cruising
conditions.
The power trim/tilt system operates
when the switch is pressed, and it
stops when the switch is released.
To trim up slightly, press on UP
momentarily but securely.
To trim down slightly, press on DN
(down) in the same manner.
Trimming the Outboard Motor
68°
TILT ANGLE
TRIM ANGLE
(when transom angle is 12°)
(VERTICAL LINE)
16°
0°
– 4°
0°
12°
POWER TRIM/TILT
SWITCH
Press UP to
raise bow.
Press DN to
lower bow.
POWER TRIM/TILT
SWITCH
Press UP to
raise bow.
Press DN to
lower bow.
(R1 type)
REMOTE
CONTROL
LEVER
(R2 type)
REMOTE
CONTROL
LEVER
POWER TRIM/TILT
SWITCH
Press UP to
raise bow.
Press DN to
lower bow.
POWER TRIM/TILT SWITCH
(LEFT)
(RIGHT)
(R3 type)
(Single Type)
(Dual Type)
REMOTE
CONTROL
LEVER
REMOTE
CONTROL
LEVER
36ZVTT00_EN.book 65 ページ ２０２１年１１月１９日 金曜日 午後３時２１分