89
MAINTENANCE
Engine Oil
Insufficient or contaminated engine
oil adversely affects the service life of
the sliding and moving parts.
Oil change interval:
20 operating hours after the date of
purchase or first month for initial
replacement, then every 100
operating hours or 6 months.
Oil capacity:
6.5 L (6.9 US qt, 5.7 Imp qt)
…when oil filter is not replaced
6.7 L (7.1 US qt, 5.9 Imp qt)
…when oil filter is replaced
Recommended Oil:
SAE 10W-30 engine oil or
equivalent, API Service category SG,
SH, SJ or SL.
Engine Oil Replacement
Drain the oil while the engine is still
warm to assure rapid and complete
draining.
1. Position the outboard motor
vertically, and remove the engine
cover (see page 41). Remove the
oil filler cap.
2. Place a suitable container under the
guide.
3. Remove the engine oil drain bolt
and sealing washer using the 12
mm wrench and drain the engine
oil.
Install a new sealing washer and drain
bolt, and tighten bolt securely.
TIGHTENING TORQUE:
23 N·m (2.3 kgf·m , 17 lbf·ft)
SEALING WASHER
(Replace)
OIL DRAIN
GUIDE
DRAIN BOLT
36ZVTT00_EN.book 89 ページ ２０２１年１１月１９日 金曜日 午後３時２１分
To Next Page
