TOHATSU BFT 150D - Cruising

62
OPERATION
1. Press on the DN (down) of the
power trim/tilt switch on the
remote control lever and trim the
outboard motor at the lowermost
position.
R3 type:
When the two outboard motors are
mounted:
1) Press on the DN (down) of the
power trim/tilt switch on the
remote control lever and trim the
outboard motors at the lowermost
position.
2) With the outboard motors trimmed
at the lowermost position, adjust
the trim angle of the right and left
outboard motors using the switch
on the remote control lever
simultaneously.
Cruising
(R1 type)
POWER TRIM/TILT
SWITCH
(R2 type)
LOWERMOST
POSITION
POWER TRIM/TILT
SWITCH
(dual type)
POWER TRIM/TILT
SWITCH
(LEFT)
(RIGHT)
POWER TRIM/TILT
SWITCH
(R3 type)
(single type)
36ZVTT00_EN.book 62 ページ ２０２１年１１月１９日 金曜日 午後３時２１分